Page 1 of 1
[5203] Analog clips drops chord when looping a sequence
Posted: Tue Mar 17, 2009 1:09 am
by Chicle777
If I hold down a key on Analog when looping a sequence in Arrangement view the audio clips when looping point is reached. Holding a chord down in REC mode drops a note in the chord or sometimes the hole chord when looping point is reached the second time around.
beta 20
Re: [amo] Analog clips drops chord when looping a sequence
Posted: Wed Mar 18, 2009 4:17 pm
by Amaury
Hi,
I'm not quite understanding what I should do and problem I should observe. Can you give more precise instructions?
Regards,
Amaury
Re: [amo] Analog clips drops chord when looping a sequence
Posted: Wed Mar 18, 2009 5:05 pm
by Chicle777
In arrangement view, put a bar in loop mode, press record, hold down a midi chord and let it run 2 loops.
Re: [5203] Analog clips drops chord when looping a sequence
Posted: Wed Mar 18, 2009 5:22 pm
by Amaury
Hi,
I could reproduce that the note(s) is dropped after a second Arranger loop jump, when recording a note into a MIDI clip, in the Arranger. This is not dependent on Analog for me, it also happens with Operator.
This sounds like what you are experiencing right?
Regards,
Amaury
Re: [5203] Analog clips drops chord when looping a sequence
Posted: Wed Mar 18, 2009 5:48 pm
by Chicle777
That´s right. And when you reach the end of the loop the sound clips.
Re: [5203] Analog clips drops chord when looping a sequence
Posted: Thu Jan 21, 2010 2:03 am
by Alex
This one should be fixed since Live 8.0.4.
I'll move this thread into the 'Done' section.
Regards
/Alex