Page 1 of 1
[amo] scene select 'offset'
Posted: Wed Mar 25, 2009 9:27 am
by shai
not sure what led to that, but in some point scene was selected (say, scene 17) and the actual scene that it corresponded to was 14. i was launching the scene from the master scene row. if i went one scene higher or lower, it still kept this gap of 4 scene offset.
it stopped when i launched a clip individually, and the master scene got in sync again.
couldnt be reproduced. sorry. .
Re: [amo] scene select 'offset'
Posted: Thu Mar 26, 2009 4:30 pm
by Amaury
Hi,
As to try getting a clue:
- How were you navigating the scenes? mouse click? computer arrow keys? Remote mapping?
- Do I understand well that you had a scene selected, and in the clip area another one was highlighted?
Regards,
Amaury
Re: [amo] scene select 'offset'
Posted: Thu Mar 26, 2009 4:55 pm
by shai
Amaury wrote:Hi,
As to try getting a clue:
- How were you navigating the scenes? mouse click? computer arrow keys? Remote mapping?
navigated with the computer arrow keys
Amaury wrote:
- Do I understand well that you had a scene selected, and in the clip area another one was highlighted?
you understand well
Re: [amo] scene select 'offset'
Posted: Thu Mar 26, 2009 5:15 pm
by Amaury
Hi,
I'd be very interested if you can reproduce this and give me a step by step scenario, so that I can also reproduce it here.
Regards,
Amaury
Re: [amo] scene select 'offset'
Posted: Thu Mar 26, 2009 5:58 pm
by shai
i'll do my best. as i said, it didnt work till now, but i let you know if it does