Ableton Forum

This applies only to AAS instruments and Live 8.01

When changing the octave from the controller, the volume on all AAS Suite Instruments (except Collision) will drop to -42db or -44db on the master instrument volume. At the same time another instrument-dependent parameter will change.

-Analog (Filter One Freq will change)
-Collision (Mallet Volume>Velocity AND Structure selection will change)
-Electric (Mallet Stiffness will change)
-Tension (Excitator type will change)

MIDI-OX reports the Octave Up/Down command from the controller as CC:Pan and CC:Harmonic Content.

Hi ibbur,

does this happen in every set or just in a particular one?

Regardless of the answer to this question, please send a set in which this is reproducible to [email protected]
Just the .als file, samples are not necessary!

Thank you!

best,
dfi

This happens on any set. As you requested I am sending an als file to ableton support. I opened a fresh project, loaded up Analog, Collision, Electric, and Tension without preset selections. Then one at a time I armed each midi track, pressed the Octave +/- on the controller and the unwanted parameter changes occurred.

This behavior did not exhibit in L7 Suite.

I will include more details in the email accompanying the file. Thanks!