Ableton Forum

Is it possible to have this fonction in live audio routing

Have the choice to send signal in \"aux\" by 2 way:
1° normal way
-move the \"send\" bouton (1,2,3 or 4) to mix a track with aux effect(1,2,3 or 4).

2° \"group\" \'s way
-assign the signal to the \"aux\"(1,2,3 or 4) at the track output . So, all the signal is routed to the \"aux\".You can use the \"aux\" like group !

Thanks for your answer
Tof

Hi,

A pre/post switch on the aux send would be handy, that should give about the same result.

FrankH

FrankH wrote: Hi,

A pre/post switch on the aux send would be handy, :) that should give about the same result.

FrankH

It's already there! Look in the master column, at the same height as the send knobs

I was speaking about a total signal rooting to the aux (or bus).
With pre-aux you are just abble to mix the track signal with the aux signal.
Have acces to aux at the TRACK OUPOUT is more quick and easy !

Thanks

Tof