Using the Roland FC300 for looping
Posted: Sun Jul 26, 2009 1:48 pm
OK so I am still a newbie here, but i must say im loving the abelton live 8 for live looping - i moved up frmo a roland rc-50 and i am DIGGING This stuff!
However
is there a way, to use a single pedal to control a loop in a similar fashion as im used to on the rc-50? meaning that if I set switch 1 to start the loop, can i use switch 1 again to stop the loop, and then again ue switch 1 to rearm the loop?
I currently have to assign 3 different switches 1 to start 1 to play back and 1 to over dub - is there a better way to do this?
thanks in advance
C
However
is there a way, to use a single pedal to control a loop in a similar fashion as im used to on the rc-50? meaning that if I set switch 1 to start the loop, can i use switch 1 again to stop the loop, and then again ue switch 1 to rearm the loop?
I currently have to assign 3 different switches 1 to start 1 to play back and 1 to over dub - is there a better way to do this?
thanks in advance
C