Ableton Forum

on my sub bass layer whenever a note is release a click happens... i have tooled around with the setting in operator to no avail... any insight?

i think i have the same problem here... low octave sine waves acts like it was pressed twice, so you can hear a small click. Was it always like this?

record it to some audio-track and investigate the wave form. maybe the release was too short so it get cut without having enough time to go down to the zero-line again? i always forgot that..

below 100 hz a longer release needed, at least one cycle of a waveform, especially if its a sine wave. this is not an operator issue. this "issue" happens with every synth except if there is a built-in algorithm that modify the release characteristic

Here we go again with this issue.

This is my sub bass (a default Operator preset sine repeated on quarters):
http://www.box.com/s/r5em681ro28gavvvl6ts

How can i get rid of those click?