Ableton Forum

After looking around for a decent stand for my APC40, and seeing how expensive stands are I decided to make my own.





Materials used PVC pipe/ connectors / Hack saw / Measuring Tape.

Results very sturdy, and comfortable.

Not finished yet because I have to prime and paint.

Nice. Did you glue the joints?

If he did, he didn't prime the joints!!!!


I'm a pipefitter, so of course I like it!!!!!

U did good. You should start selling them.

inspiring, looks cool.

i'll have to check out if i find pipes somewhere around here

this looks great. seems i'll be going to home depot this weekend lol

I wonder if that would fit around a turntable so you could put it over one in a DJ booth.

Do they come in black?

digitalgeist wrote:I wonder if that would fit around a turntable so you could put it over one in a DJ booth.

i wonder and think about such an installation right now, too

Thanks everybody for your comments. The joints are not glued yet that will be this weekend and then comes the primer and paint. I will paint it all black so it could match the APC40. Any suggestions ?

antonio913 wrote:Thanks everybody for your comments. The joints are not glued yet that will be this weekend and then comes the primer and paint. I will paint it all black so it could match the APC40. Any suggestions ?

Yeah, clean your room. It's a mess!!!!

this looks like a laptop stand that is out there, search the forums you'll find it, they have yellow black and white, swear looks just like that, pipe tubing and all.

yes there is a laptop stand made out of the same materials. The difference is the price. My method cost me under $20.00 dollars (3/4" PVC pipe, connectors, white primer, flat black paint). Now if you order the one u saw online it's going to cost you about $70.00 dollars. Just finished bonding the joints and tomorrow will be primer and paint day stay tuned!!!!!

Nice work, Antonio

You like it at that angle? I guess it depends on where/how you're sitting..