Envelope stopped working
Posted: Mon Nov 01, 2004 8:00 am
I had automated a volume envelope on an audio track in the Arranger. It worked fine four about three plays then refused to work again. The volume basically starts at zero then rises to just under 0 db. Any ideas on why this happened (it's possible I fiddled with something unwittingly).
Secondly, I set up 3 audio tracks in Session and set the warp and loop options on. Then I went to arrange view and dragged the same audio files from the browser into the tracks (this was prior to figuring out that you can drag from session view
). However, when I start the arrangement the audio clips are grayed out and do not sound. Deleting all clips from both views and just dragging into the existing arrange tracks still result in grayed out clips (however, inserting into a new audio track works fine). Again, any ideas on what I did??
Thx
4.04 XP Sp2
Secondly, I set up 3 audio tracks in Session and set the warp and loop options on. Then I went to arrange view and dragged the same audio files from the browser into the tracks (this was prior to figuring out that you can drag from session view
). However, when I start the arrangement the audio clips are grayed out and do not sound. Deleting all clips from both views and just dragging into the existing arrange tracks still result in grayed out clips (however, inserting into a new audio track works fine). Again, any ideas on what I did??Thx
4.04 XP Sp2