Ableton Forum

I'm going to be making my own studio mixer using for Ableton, any suggestions on what controllers to use? Was thinking of using a combination of the BCR2000's and BCF2000's, but are there any other controllers I should e aware of? Was thinking about using the UC33's instead of the BCRs because I get the additional knobs per channels, and I would like to have a decent amount of knobs per channel.

Thanks and appreciate the advice/help!

is this for studiouse or liveuse?
if it is mainly for studio i would recomend you to check out some controllers that has automap.
'cos you don't bother to manually map every knob every time =)

http://www.gearslutz.com/board/low-end- ... 2000s.html

an idea I had a while back and never acted upon.

Someone did though! check out a few pages into the thread and you'll see the results

That's brilliant! And yes, it would be for studio use. I know the Novation controllers have auto map, but for the cost of it, it would be expensive to get a 24x8 mixer. I really like that BCR/BCF set up, thanks for posting!

babkubwa wrote:http://www.gearslutz.com/board/low-end- ... 2000s.html

an idea I had a while back and never acted upon.

Someone did though! check out a few pages into the thread and you'll see the results

Nice.

These are good http://www.tascam.com/products/us-2400.html

i got one recently