APC can't access Parameters of VST Peavey Revalver but...
Posted: Mon May 17, 2010 6:02 am
APC can't change Plug In Parameters of "VST Peavey Revalver" but If I change the mapped parameter by mouse in the Revalver window the APC will follow ?
Revalver is the only commercial VST I own but a freeware JX220 works fine in both directions.
This also means I can't automate the parameters or map my FCB1010 expession pedal to the WaWa
Which is a problem I had back in Live7 but it would work as long as I never touched the Revalver control, but this no longer works since the updated select your own parameters method.
Maybe the fault is with my amp sim
Revalver is the only commercial VST I own but a freeware JX220 works fine in both directions.
This also means I can't automate the parameters or map my FCB1010 expession pedal to the WaWa
Which is a problem I had back in Live7 but it would work as long as I never touched the Revalver control, but this no longer works since the updated select your own parameters method.Maybe the fault is with my amp sim