Ableton Forum

hi,

i don't use my APC40 much so decided to sell it.
i just connect it to check if all is all right and was surprised to see a rotary knob acting weird.
it is not "accurate" if i move it slowly the leds above or below goes flashing and the values sent to live and random. when i stop moving the knob values keep moving a little then stops :S

i tried ti assign knob to midi and got same result so i guess this knob has a problem.
did anyone heard about that ?

i'm just trying to make sure it's not an "update" problem before i send it back to akai.

well...
it's working now

can't figure out what happened.
i'll check that tommorrow again. pf that's weird.