Ableton Forum

I've been having this issue with certain midi clips that I try to automate the pitch bend within the clip its self. If I draw in a pitch bend that ends at the end of the clip, it seems to carry on to the next clip(s), until i nudge the pitch wheel on my midi controller, so it fixes itself. Within the automation line that I'm drawing, I'm not reseting the position back to normal at the clip's end, but I didn't think I would have to. I'm fairly certain this is happening with multiple VSTi's so I'm thinking its an ableton 7 issue.

anyone else run across this?

Yes, you'll need to either reset the pitch bend at the end of the clip, or reset it for the next clip that you want to play.

Yes, and this has been an annoyance to me for ages. I think it should automatically reset to zero if no automation is present.

Yeah this has been annoying me for while too. It should just go back to zero automatically when the new clip starts.