Novation Remote Zero SL & Ableton Live 8
Posted: Fri Jan 21, 2011 1:15 pm
Hi,
I have just got a Novation Remote Zero SL. I am looking to set it up as a DJ controller in Ableton live.
At this stage I am not looking to use the Automap software or anything too fancy, I just want to be able to set the midi mappings myself within Ableton.
I can set the faders on the right hand side without a problem but I want to be able to use the 2 buttons just below (2 rows of 8 below the faders) to start and stop clips. I can assign the control in the midi mapping software and it accepts it, but then does nothing when I try to use it...
I suspect it is to do with the internal templates or something along those lines. Essentially I just want to be able to start with a blank canvas and assign controls that I specify as I normally would in Ableton, it is just these 2 rows of 8 buttons that won't seem to map.
Any ideas?? Thanks, Steve.
I have just got a Novation Remote Zero SL. I am looking to set it up as a DJ controller in Ableton live.
At this stage I am not looking to use the Automap software or anything too fancy, I just want to be able to set the midi mappings myself within Ableton.
I can set the faders on the right hand side without a problem but I want to be able to use the 2 buttons just below (2 rows of 8 below the faders) to start and stop clips. I can assign the control in the midi mapping software and it accepts it, but then does nothing when I try to use it...
I suspect it is to do with the internal templates or something along those lines. Essentially I just want to be able to start with a blank canvas and assign controls that I specify as I normally would in Ableton, it is just these 2 rows of 8 buttons that won't seem to map.
Any ideas?? Thanks, Steve.
