Ableton Forum

Hello,

I was wondering if I could change how I have to move faders and knobs a pre-determined amount before they become active in controlling ableton. This is especially the case when I MIDI remap the sends to effects. When I change the send bank on the APC when performing, I have to turn all those knobs to even use the effect.

Thanks,

Dustin

Not sure, if I understand you correct, but you can alter min/max values in the left side browser while Live's in midi mapping mode. Check that out, in case you haven't done so yet.

Also change your takeover mode to value scaling...

Cheers
D