Page 1 of 1
Problem with MIDI Mapping
Posted: Tue May 31, 2011 9:32 pm
by themanateewarrior
So, I remapped my APC. when I change the MIDI map, there's a label that says "Note/Control" with a corresponding "1/C2 or Note C2." The button is remapped like it's supposed to, but that piano note sounds when I press the button. How do you make it so that no note sounds? For instance, if I set "Activator" in Channel 1 to activate Beat Repeat for Channel 1, it sounds a D2.
Re: Problem with MIDI Mapping
Posted: Wed Jun 01, 2011 1:02 pm
by www.midischool.com
Do you have any instruments loaded into your set, and if so, is/are the track(s) armed for recording?
Re: Problem with MIDI Mapping
Posted: Thu Jun 02, 2011 8:18 am
by themanateewarrior
www.midischool.com wrote:Do you have any instruments loaded into your set, and if so, is/are the track(s) armed for recording?
No instruments. Even if I have no tracks, audio, or anything there is still the keyboard note. I think Ableton thinks my APC is a MIDI keyboard. I checked and made sure I only have "remote" on for both input and output for the apc.