Page 1 of 1
APC40+APC20 Combination Mode Issue
Posted: Sun Jul 03, 2011 12:40 am
by Blankman8503
I use an APC40 and an APC20 in Combination mode and sometimes when I open sets the grids switch with the 40 being on the left and the 20 on the right. I can easily fix this by going into MIDI preferences and turning the APC40 off and then back on again. I was wondering what might be causing this problem and how it might be fixed.
Re: APC40+APC20 Combination Mode Issue
Posted: Tue Jul 05, 2011 3:32 am
by skatr2
By default, the first mentioned controller in the pref list is the one on the left.
Re: APC40+APC20 Combination Mode Issue
Posted: Sun Oct 07, 2012 2:12 pm
by metasymbol
skatr2 wrote:By default, the first mentioned controller in the pref list is the one on the left.
Not always. Sometimes the APC40 loads after theAPC20, so the layout is interchanged.
The only workaround I found "open Pref, remove Remote Controller APC20, add it again and then it works".
Sometimes it interchanges midst a session, eg when a new (virtual AU) midi device is started.
This can be a performance killer.