Page 1 of 1
Live/Reason Rewire problems
Posted: Fri Feb 11, 2005 12:00 am
by spastic
Sorry if this is idiotic, but I am new.
I want to make Reason the slave in live, but it isn't on the pull-down menu. When I first installed them, I opened reason first, which has probably screwed up my rewire setting. Is there any way to reset them?
Thanks
REWIRE
Posted: Fri Feb 11, 2005 3:24 am
by jasonjbundy
In order to make Reason the slave using REWIRE in Live 4:
1. Open Live 4 - wait until it initializes and scans, etc...
2. Then once Live 4 is completely and fully loaded, open Reason and you are done.
3. Look for Reason among the audio and the midi to channels.
Good luck!
Posted: Fri Feb 11, 2005 9:51 pm
by spastic
Yeah, it doesn't do that. Reason never appears in the channels.
Posted: Mon Feb 14, 2005 3:50 am
by clipperer
reinstall reason?
Posted: Mon Feb 14, 2005 5:59 am
by ewistrand
Easiest thing to do is to do a search for ReWire.dlls on your machine.
Delete ALL of them that appear. Now, run your Reason installer again.
It'll put the correct ReWire.dll in the correct location- all the installer will do in this case is replace missing files. Then start up Live. After it's through initializing and completely open, start up Reason.
ew