Ableton Forum

Hey,

just got one little problem which i can't seem to solve by myself...

I got an apc40 and bought a sustain/hold pedal for it. (VFP 1/25)

When I plug it in my akais FS1 input it sends a CC#64 just as it should do.

But how can I set it up to work as a simple sustain/hold pedal. I really just want to be able to hold a note or some notes when I use my guitar synth to free my hands...

Any help would be appreciated

Thx you guys

push

If I recall, the apc uses that jack to send a midi note. Do you have any other devices? A keyboard??

First; Thanks 4 your reply!

2nd; Unfortunately no! Only my Roland Guitar Synth which I want to be able to use the pedal with :O

Again, the pedal works just fine but just starts/stops the selected clip when I press it (without any Midi-mapping, checked it a thousand times) - looks like this is the global setting for my cc64-message, but why!?!?

Any hints?

Thx again

cheers from vienna

Been trying to figure this out again today. still no luck.

come on. there must be an answer to this!

The pedal sends a CC 64 message. That's for sure. I used a monitoring program to check that. But by default it doesn't sustain ANYTHING. It just starts the selected clips in session view.

ANY HINTS? please... I'm desperate!