Distortion on kick during Simplon filter automation!
Posted: Thu Nov 03, 2011 3:52 pm
I'm doing an 8 bar high pass filter sweep automation using a Simplon (like you would use Autofilter or EQ8) into a breakdown but part way through the automation the kick starts sounding horrible but not sure why?
I've tried reducing the peak (res/Q) but no difference so I only imagin it is filtering frequencies out the kick that is conflicting with the way I've EQ'd it.
In the mix it sounds ok but if I solo the 'low end' group with sub bass and bass tracks it sounds bad and I would imagine on a big system it would sound dreadful.
Kick is quite EQ'd and has a Sonnox Transmod on it.
My group has and EQ8 with 275Hz 1db and 30Hz roll off, a Glue compressor, Sonnox Limiter, the the Simplon automating.
Turning off the plug-ins and devices makes no difference.
Any ideas please?
Thanks
I've tried reducing the peak (res/Q) but no difference so I only imagin it is filtering frequencies out the kick that is conflicting with the way I've EQ'd it.
In the mix it sounds ok but if I solo the 'low end' group with sub bass and bass tracks it sounds bad and I would imagine on a big system it would sound dreadful.
Kick is quite EQ'd and has a Sonnox Transmod on it.
My group has and EQ8 with 275Hz 1db and 30Hz roll off, a Glue compressor, Sonnox Limiter, the the Simplon automating.
Turning off the plug-ins and devices makes no difference.
Any ideas please?
Thanks