Page 1 of 1
Creating automation breakpoints without double-clicking?
Posted: Fri Dec 16, 2011 9:04 pm
by chrisdavis
Is there a shortcut to create automation breakpoints without double-clicking on the line? Specifically, when you've set your cursor somewhere on the grid? I usually try to be exact, and having to repeatedly zoom in when creating automation seems inefficient, especially since the point in time has already been selected on the grid.
Sorry if this question has been answered before; I searched but couldn't find anything.
Thanks!
Re: Creating automation breakpoints without double-clicking?
Posted: Fri Dec 16, 2011 9:31 pm
by regretfullySaid
Hint: Pencil
Re: Creating automation breakpoints without double-clicking?
Posted: Fri Dec 16, 2011 10:20 pm
by simmerdown
single-click twice in quick succession
friend: pencil off, shift drag...super useful
Re: Creating automation breakpoints without double-clicking?
Posted: Fri Dec 16, 2011 11:03 pm
by regretfullySaid
+ Ctrl/CMD 1 & 2
Re: Creating automation breakpoints without double-clicking?
Posted: Mon Dec 19, 2011 6:57 am
by chrisdavis
shadx312 wrote:Hint: Pencil
Not exactly what I was hoping for, but this will do the job. Thank you!
simmerdown wrote:single-click twice in quick succession
jokes?
simmerdown wrote:shift drag...super useful
What does that mean? Do you mean while warping?
shadx312 wrote:+ Ctrl/CMD 1 & 2
Knew that one before, but along with the pencil that is an excellent tip
Re: Creating automation breakpoints without double-clicking?
Posted: Mon Dec 19, 2011 4:18 pm
by simmerdown
also key....hold alt in pencil mode
shift drag on a breakpoint toward other breakpoints and you'll see, no joke