Fix Sidechain mistake 1 of 2 ways ?
Posted: Sun Mar 04, 2012 7:25 pm
Bounced all my midi drums to audio, have an Operator sine wave sub (& some pads) side chained to the kick. Forgot sub compressor's SC input was post FX from the kick, not Post Mixer, so now there's a 15 db (!) difference in what the sub bass compressor is detecting/listening to. I had the kick channel fader pulled down because it was eq'd, limited, compressed etc.
So, should I A.) Go back to the old midi drums set and record the Operator sub to audio? There might be ever so slight differences in the kick level that it's now listening to as opposed to when I bounced the midi/Simpler kick to audio the first time.
Or should I B.) Crank up the compressor's side chain input gain to compensate for the quiter signal it's getting from my new audio kick file? This works for getting the sub's gain reduction & channel level back to where it was, I'm just worried if that will effect the kick. Might be my imagination, don't know if it bleeds through the sub bass at all really.
This is how bad I am at music production, such a simple mistake. Two ways to fix it, not sure if it matters which way. Thanks for any help you could offer.
So, should I A.) Go back to the old midi drums set and record the Operator sub to audio? There might be ever so slight differences in the kick level that it's now listening to as opposed to when I bounced the midi/Simpler kick to audio the first time.
Or should I B.) Crank up the compressor's side chain input gain to compensate for the quiter signal it's getting from my new audio kick file? This works for getting the sub's gain reduction & channel level back to where it was, I'm just worried if that will effect the kick. Might be my imagination, don't know if it bleeds through the sub bass at all really.
This is how bad I am at music production, such a simple mistake. Two ways to fix it, not sure if it matters which way. Thanks for any help you could offer.
