Page 1 of 1
creating drumrack, setting parameters for multiple samples?
Posted: Fri Mar 09, 2012 6:54 pm
by chaosmoon
So i'm creating say a drumrack with samples from a DR660. is it possible to select all the samplers and set the voices to 1 without doing each sample separately?
i want to multi select, then:
voices to 1
release to 60s
output to 0dB
Re: creating drumrack, setting parameters for multiple samples?
Posted: Fri Mar 09, 2012 9:46 pm
by Mage2k
Yes. Pick any device in the rack. Set it's voices to 1. Then right click on the parameter and choose Copy Value to Siblings. Note that this does not work for macro mappings/unmappings, just setting the actual values of the parameters.
Re: creating drumrack, setting parameters for multiple samples?
Posted: Fri Mar 09, 2012 10:16 pm
by chaosmoon
wonderful, thanks.
it doesn't seem to show up for the voice numbers, but already will save me a lot of repetitive work.
Re: creating drumrack, setting parameters for multiple samples?
Posted: Mon Mar 12, 2012 8:53 pm
by regretfullySaid
It doesn't work on Voices or the R button next to it:/
This is as bad as not being able to map all siblings to a macro.
Re: creating drumrack, setting parameters for multiple samples?
Posted: Tue Mar 13, 2012 3:53 am
by Mage2k
Doh! My bad. I'd never tried to set all of the voices like that before and was at work when I replied so I wasn't able to double check it first.
Re: creating drumrack, setting parameters for multiple samples?
Posted: Tue Mar 13, 2012 4:20 am
by regretfullySaid
Ay it's cool I just tried it again recently:/
It's one of those things where you're half surprised it doesn't do it and half not:p
Re: creating drumrack, setting parameters for multiple samples?
Posted: Tue Mar 13, 2012 10:26 am
by chaosmoon
is there anywhere to submit feedback to ableton or do they monitor the forum?