Is my BCF200 dead?
Posted: Sun Mar 13, 2005 9:44 pm
Can't find the answer to this on the Behringer forum so I thought I'd ask here.
I've been using Live for a while now and I just bought the BCF2000 controller to use with Live this weekend. It seemed to be working fine, I updated the firmware and the USB driver from the Behringer page and I started to map it to Live, saved all the presets, turned it off and went to bed happy! Next morning, I powered up the BCF200 and the display read "noO5", which I assume means "no operating system"? The Store and Learn buttons are illumated on the BCR. If I re-power the BCR with these buttons pressed, the display reads "LOAD" but my computer does not recognize the BCR as a USB device (or any other kind of device!) so I can't use the firware update program from Behringer because it doesn't find the BCR.
Has anyone else experienced this? Or is my BCR dead?
I've been using Live for a while now and I just bought the BCF2000 controller to use with Live this weekend. It seemed to be working fine, I updated the firmware and the USB driver from the Behringer page and I started to map it to Live, saved all the presets, turned it off and went to bed happy! Next morning, I powered up the BCF200 and the display read "noO5", which I assume means "no operating system"? The Store and Learn buttons are illumated on the BCR. If I re-power the BCR with these buttons pressed, the display reads "LOAD" but my computer does not recognize the BCR as a USB device (or any other kind of device!) so I can't use the firware update program from Behringer because it doesn't find the BCR.
Has anyone else experienced this? Or is my BCR dead?