Ableton Forum

I noticed that once I adjust the Master volume via Push I can't get it right back at 0db from Push...it's either a little above 0db or a little below. I was thinking that holding shift while adjusting it would give me a 'fine' movement but it doesn't. Is there a way to move volume with a 'fine' adjustment rather than the 'course' that it seems to be set at?

thanks

I think it's not possible, push send midi CC value, 128 steps, so holding shift it's exactly the same step!
I think they must introduce fine tuning in the Script!

There definitely needs to be fine tuning. Can't believe this isn't already integrated...

the manual sez

Holding shift while turning the Volume with increase or decrease by .1

I'm not at my studio to confirm but I remember reading that.

SuburbanThug wrote:There definitely needs to be fine tuning. Can't believe this isn't already integrated...

Yes or some way to default it back to 0db

Asymmetricalmusic wrote:the manual sez

Holding shift while turning the Volume with increase or decrease by .1

I'm not at my studio to confirm but I remember reading that.

Doesn't work. At least not on my end.

Shift hasn't worked for me either...

Asymmetricalmusic wrote:the manual sez

Holding shift while turning the Volume with increase or decrease by .1

I'm not at my studio to confirm but I remember reading that.

that's for tempo, not master volume. holding shift while turning tempo knob will change tempo by 0.1 for every "click" of the knob.

holding shift and turning master volume knob adjusts the cue volume.

a more sensitive mode for knobs is definitely needed!

That makes more sense, Thanks