Page 1 of 1
Have you had Push freeze...
Posted: Wed Apr 10, 2013 12:15 am
by Upright
Have you had Push freeze up and then get an error/crash in Live on Windows? Happen to me twice today so far.
Re: Have you had Push freeze...
Posted: Wed Apr 10, 2013 3:07 am
by Upright
I figure out my problem here. I had Push set wrong in Preferences.
Re: Have you had Push freeze...
Posted: Wed Apr 10, 2013 9:04 am
by Ryder17
Ive had push freeze but not live.... luckily all I need to do is turn push off and on again
Re: Have you had Push freeze...
Posted: Wed Apr 10, 2013 12:25 pm
by Evengy
yesterday i turned push on, started live and live crashed (hanging). i tried it again = crash, again = crash, after restart = crash. starting live without push and then turning it on = it works
i have also some freezes while i add devices or tracks etc. i don´t know why live is waiting for processes etc. or why they programmed it like this.
Re: Have you had Push freeze...
Posted: Wed Apr 10, 2013 2:17 pm
by Upright
Evengy wrote:yesterday i turned push on, started live and live crashed (hanging). i tried it again = crash, again = crash, after restart = crash. starting live without push and then turning it on = it works
i have also some freezes while i add devices or tracks etc. i don´t know why live is waiting for processes etc. or why they programmed it like this.
My problem was in Preferences. I have 3 control surfaces connected to Live. An Mpd 32, Axiom 49 and Push. Somehow the top row, which is set to be the MPD 32 and Push as the Control surface and the MPD32 as the input and output. The second row, which is normally set to Push had nothing as a control surface and Push for the input and output. Make sure that your control surface for Push say Push all the way across one row and that Push is not selected anywhere else in the control surface section.