Ableton Forum

ive been trawling thru here but i cant see what im after.

when i load a device Push selects the parameters the 8 knobs will control - can i change these?

when i load a few devices in the chain can they be rearranged via Push?

when I load and EQ8 the default parameters are 3-6 but Push takes control of 1-4. duh.

I cant figure out how to browse the folders in my Places eg to load samples.

cant add an audio track? disappointed in that.

also control of loop length is a bit clumsy

it looks like ill have to set up a lot of my own kinda presets for stuff i wanna do that Push wont automatically do. Its not as "straight out of the box" as i expected.

maybe this is just stuff that will be gradually updated over time.

To add an audio track hold the add track button and you will be presented with a selection to add an audio track.

"when i load a device Push selects the parameters the 8 knobs will control - can i change these?"



make a rack, and macro map the rack as you like, then save a preset and use that in the future.

lyovino wrote:To add an audio track hold the add track button and you will be presented with a selection to add an audio track.

ah great thanks!

lo.key wrote:"when i load a device Push selects the parameters the 8 knobs will control - can i change these?"



make a rack, and macro map the rack as you like, then save a preset and use that in the future.

oh i use macros already, i just want to be able to do it thru psh rather than the way i normally do it.