Problem with Clip Automation
Posted: Sun Jun 16, 2013 2:36 am
I'm using the new clip automation in live 9 and something that's really annoying is that when a clip loops it basically turns session record off until you give it input again. Now I know it isn't actually turning off the record button but it may as well be.
Say I wiggle a knob around then want it to just hold a value for a few seconds. If the loop restarts during this hold it just goes back into playing back the data it got during the last loop. This doesn't happen in a loop in the arrangement view.
I want it to not stop recording my input until I actually turn off the record button, just as it would in the arrangement view.
Say I wiggle a knob around then want it to just hold a value for a few seconds. If the loop restarts during this hold it just goes back into playing back the data it got during the last loop. This doesn't happen in a loop in the arrangement view.
I want it to not stop recording my input until I actually turn off the record button, just as it would in the arrangement view.