Ableton Forum

I saw ont he board a while back people trying to figure this out. Any progress? Also Id like to be able to mix between 2 tracks using the knobs except I can only use the one set of knobs on top for 1 track. Ususally When I DJ I do phase mixing (cuting out the low end as you bring in the new tracks low end_ but I can only handle 1 track on the knobs at a time. Perhaps a new DJ template is in the works?

bump

https://www.ableton.com/en/articles/push-user-mode/ ??

Not sure about the slider though, because it appears to have 'snap back' behaviour...

OT: Thanks for pointing to this article The Finn! I missed that one until today:

"For the output User Port, the Remote switch needs to be enabled to allow visual feedback via Push's LEDs."

The Finn wrote:https://www.ableton.com/en/articles/push-user-mode/ ??

Not sure about the slider though, because it appears to have 'snap back' behaviour...

Perhaps there can be a script written to turn this off. There has to be a way to make this more functional to DJ with solo.

JLaws wrote:

The Finn wrote:https://www.ableton.com/en/articles/push-user-mode/ ??

Not sure about the slider though, because it appears to have 'snap back' behaviour...

Perhaps there can be a script written to turn this off. There has to be a way to make this more functional to DJ with solo.

Anyone else figured out how to turn that part it off?

Might this article be of assistance?
http://www.soundonsound.com/sos/sep07/a ... h_0907.htm

I accidentally had the track and remote switches enabled on the Push Inputs and Outputs (Live Port) and was trying to work with a set in session view... got some strange behavior. The Selection Control buttons would turn green, underneath audio effects listed in my tracks, (I was in device mode), and if I pushed the selection control buttons, they would move the faders in a punch-in, punch-out fashion, going from -inf volume to maximum value.

So many places for something to go wrong. Keeps me busy for hours troubleshooting sometimes.