Ableton Forum

I've had the Push just over a week now and I'm pretty amazed at all it can do. Still, I was under the impression that I could potentially control all of the in-depth parameters of at least the built in synths, if not any synth I throw at it. I was hoping I'd be able to design new sounds from scratch using Operator, Analog, Collision, etc. I tried doing this just now in analog, and I didn't see any way to enable Oscillator 2 from the default patch via device mode in push. I loaded up Collision and didn't see how to enable resonator 2.. and with Operator I couldn't change waveform types for any of the operators. Am I missing something or are these mappings very incomplete?

They are incomplete.

And I think it'd be nice if things were changed in favor of more comprehensive control.

Until that day...A couple workarounds:

1. Always loading the devices embedded in a Rack which would have access to those parameters.

2. There was a small program out there that let you change the default device control parameters. I played with it a while back on Live 8. I don't know if it has been updated for 9. I think there are some words of caution included with it, as using it can be potentially volatile. viewtopic.php?f=1&t=176744

Hey,

I don't have a Push, but I would like to know if this limitation is already fixed?
I would like to control Operator without touching a computer.

I will direct you to this:
viewtopic.php?f=55&t=198946

viewtopic.php?f=55&t=198946 There you go. Control ALL of Live's devices from Push. Operator works especially well.

EDIT, yur2die4 beat me to it.

And if that doesn't work, try this one viewtopic.php?f=55&t=198946
Serious.

Open each in a new tab if necessary.

-

Thanks!