Ableton Forum

Posted: **Mon Sep 02, 2013 4:59 pm**

Hi. When using a Drum Rack, I can send a Reverb by chainning audio FXs to each pad element, so I can control de amount of Reverb for each pad instead of sending the same amount for the entire Kit. ( can I call this procedure side chain also? )

Well, I was thinking about using Impulse because it's simpler and normally I don't use many drum and perc elements, so 8 pads would be just fine. But I believe I cannot to FXs chainning with Impulse, right?

Thanks in advance, Ken

Posted: **Mon Sep 02, 2013 5:38 pm**

make 8 audio tracks and set audio from > impulse and then slot1/2/3 etc

Posted: **Tue Sep 03, 2013 3:16 am**

Great, that worked just fine. But then, should I go with Impulse, Drum Rack or use several Simplers one in each track ?

Posted: **Tue Sep 03, 2013 6:54 pm**

use them all

Ableton Forum

Send FXs into each 8 Impulse Pads individually

Send FXs into each 8 Impulse Pads individually

Re: Send FXs into each 8 Impulse Pads individually

Re: Send FXs into each 8 Impulse Pads individually

Re: Send FXs into each 8 Impulse Pads individually