Ableton Forum

I have a problem that this matte covering clashes on edges. I must add that when i take it outside i use my case which is a little bit too big for it. How to prevent it?

You are very difficult to understand. It sounds like you are saying that the case you have is too big for your push? Try to get a different case or add some custom cut foam to the outside edge of the case.

Airyck wrote:You are very difficult to understand. It sounds like you are saying that the case you have is too big for your push? Try to get a different case or add some custom cut foam to the outside edge of the case.

I wanted to say that my Push has wiped out corners becouse of handling it in too big case.I thought that in some way i can prevent it but it's impossible when case has rough foam in it. It's funny that keeping Push in a plastic bag and than in case with foam prevent rubbing.

They make smaller laptop sleeves, while it wont help if you drop it or it takes a hit but it can prevent it from scratches and should fit in tight enough that it wont slide around inside the case and wear off the paint on the buttons.

Your other option would just be to wrap it in a towel or something soft and non-abrasive.

Good luck