Ableton Forum

hey qunexus people,

trying to get my qunexus to map the pressure to anything- aftertouch or not to control different parameters in live, i tried by clicking the "MIDI" button (next to "KEY" for mapping QWERTY keyboard commands) to try and get the qunexus to use pressure to control live parameters but i havent been able to do so. the editor software is a bit over my head as well and the mcmillen tutorials dont reveal too much on the actual setup so if anyone could shine some light on the matter that would be much appreciated.

thx

I've managed to set up polyphonic aftertouch and so on. Check the full manual for the CoMa mode. It will be easier to check their then me explaining.

i checked the full manual and set up coma for pressure applied to aftertouch and still was not able to midi map anything so if anyone could give me a better explanation that would be helpful

anybody?

Try asking here:

http://forum.keithmcmillen.com

graphixsounds wrote:graphixsounds

Hi graphixsounds,

I know it's been a long time but I was wondering whether you managed to make your QyuNexus talk with Live?
Whilst I can play midi notes with it just fine, I'm not able to make it talk with Live and trigger clips, arm tracks etc.

Any help would be highly appreciated

Thanks