Ableton Forum

Hey guys,

got a problem with the moving light in the Push Drum Sequencer,
after programming some notes the Moving light sometimes is not longer moving.
The drums play as usual, i can program notes, but the Light is not moving anymore...

Any Idea whats happening to my beloved moving light?

Same problem for me since update to 9.1.
When hitting play again, moving green light is present but after some modifications problem occures again.

Same issue with melodic step sequencer...

Your talking either about the new default behavior of the loop lengh control which came with 9.1 (check here the details: https://www.ableton.com/en/manual/using ... oop-length), or you're referring to the following bug which should be adressed with the next udate:

open an empty set
- press Browse and load a 606 Kit from the core library
- create a two bar loop with the step sequencer
- press Double
--> the playhead doesn’t follow bar 3 and 4, or in other words, the loop lengh controls stay in edit mode for bar 1 and 2

- press pad 1 and 4 of the loop lengh controls together, the playhead goes through the whole clip, as expected
- press Session
- press Note
--> the sequencer is in edit mode for bar 1 and 2 again...

Or you are experiencing something different and in this case you should try to reproduce when exactly it happens.

Hi Because789 and thanks for your reply!

After reading the https://www.ableton.com/en/articles/push-loop-playhead/ i have noticed this at the end of the article :
"...
Under certain circumstances, Push's Playhead may disappear or behave erratically. This is generally caused by having a loop set in Live's Arrangement view. If you experience this issue, make sure to switch this loop off."

I need to check if this solve the problem in my case.

Keep you informed.

Tested and the loop on was the problem for me!

That fixed it for mee, too! Thx a lot!!