Page 1 of 1
Clip will only record for 1 bar then start to loop
Posted: Sat Mar 29, 2014 4:46 pm
by rmacgregor
When I record a clip (midi or audio) in session view it will record for 1 bar then start to loop. I can't get it to record a longer clip. What setting need to be changed so I can record clips as long as I want? I'm sure this is something simple but I just can't figure this out.
I have:
Default Launch mode set to Toggle
Default Quantization set to Global
Re: Clip will only record for 1 bar then start to loop
Posted: Sat Mar 29, 2014 4:50 pm
by yur2die4
How are you making the clips? Sometimes people double click. You should only need to tap a record slot once and it should begin recording for a long duration, until you trigger it again.
Re: Clip will only record for 1 bar then start to loop
Posted: Sat Mar 29, 2014 6:04 pm
by rmacgregor
Single click on computer or trigger with FCB1010. It had been functioning okay.
Re: Clip will only record for 1 bar then start to loop
Posted: Sat Mar 29, 2014 6:06 pm
by chapelier fou
could you set your global quantification to 2 bars and post the results ?
Re: Clip will only record for 1 bar then start to loop
Posted: Sat Mar 29, 2014 10:52 pm
by rmacgregor
okay I figured it out. I had Touchable running too and fixed length clip had been enabled. Thanks for the suggestions.
Re: Clip will only record for 1 bar then start to loop
Posted: Sun Mar 30, 2014 9:33 am
by chapelier fou
