Ableton Forum

I am bussing everything to an audio track, selecting in and no input, and I am unable to control volume on tracks that have return sends. I want to adjust the volume on the buss track and not on the individual tracks, is there a way to accomplish this?

egb18cr wrote:I am bussing everything to an audio track, selecting in and no input, and I am unable to control volume on tracks that have return sends. I want to adjust the volume on the buss track and not on the individual tracks, is there a way to accomplish this?

im sorry i dont understand what your problem is...can you be clearer?

The easiest way is to select all the tracks you want to "buss" to and select "group"

If I'm following.

Basically when I turn the volume off on the buss I can still hear audio on the tracks that are bussed. I am grouping the tracks as well.

egb18cr wrote:Basically when I turn the volume off on the buss I can still hear audio on the tracks that are bussed. I am grouping the tracks as well.

switch the faders to post instead of pre.

switch the faders to post instead of pre.

You mean the sends? I tried switching between pre and post on the sends and I'm still having the same issue.

If I turn the sends off on the channel than I am able to adjust volume, filter, etc. But when I send signal to the return track I am no longer able to control volume as the signal goes straight to the master.

Change the output of your tracks to sends only to work in this way...

Cheers
D