Ableton Forum

In this mode, the delay time variations should be the same for right and left channel.

One could place a Utility after the GD and vary the Width parameter toward zero.

It's what I do to make a Ping-Pong Delay less stereo, instead of swapping the PPD for the Simple Delay.

But than you'll have a mono signal after Grain Delay.
I want send a stereo signal through Grain Delay and want to have a stereo signal after Grain Delay.

Now: When you use the spray parameter, GD generates different delay times for R & L channel.
My wish: These delay times should be the same for L & R channel (in the mono mode I would like to have).