Ableton Forum

https://www.ableton.com/answers/problem ... ive-tracks

Are you kidding me? Ableton doesn't preserve midi channel info when routing midi?

That is unbelievable ... this has apparently been an issue forever, and I can verify that if you route midi through a midi track and then on to another track ... all the midi will end up on the SAME CHANNEL, even if it started out on different channels !!!!

Seriously .... why would you do this? Effectively, any audio plugin which also uses midi data, and distinguishes between channels ... is useless in ableton. Great.

You're confused. I set the in and out channels in the I/O section of the tracks and it works just fine for me.

Actually it's a lot easier to do this in Live than in Cubase

Oh it selects the channels perfectly, but then gives the plugins a flattened signal (that is, everything the plugin receives is one channel 1).

Load up a plugin that distinguishes between incoming midi channels, and you'll see what I mean.