Page 1 of 1
how do i make an audio track be in stereo?
Posted: Fri Feb 20, 2015 4:48 pm
by Sebastian
If i have an Audio track set to Ext In 1/2 and the Master 1/2?
What Im trying to accomplish is sending 1 track on Ableton in stereo to a PA.
Not sure if for multiple tracks same solution?
thank you!
Re: how do i make an audio track be in stereo?
Posted: Fri Feb 20, 2015 5:17 pm
by Sebastian
most tutorials I have seen pan click track hard left and the backing tracks hard right. Does that mean the backing tracks just appear on right side of PA?
Re: how do i make an audio track be in stereo?
Posted: Mon Nov 02, 2015 2:44 pm
by BrokenOceanProd
You could just drop a "Utility" on your master or whatever track you wanna make stereo and turn width up? I use this tool to convert all of my low frequencies below ~500Hz to mono by turning width down to 0.0%, when mastering my tracks. So to make stereo or add stereo effect you would just turn the width up. Hope this helps a little