Ableton Forum

When rendering clips now, I get a loud audible click at the end of each processed wav file.

This is confirmed by a visible short spike in the level meters of the particular clip at the end of the render process. I have tried to turn off all effects before rendering, but this doesn't seem to help either.

This didn't happen before in Live 1.5...is it to do with Live 2.0, or something I am not doing right?

Thanks
Pramesh

I am having the same problem, where as I didn't in 1.5. I know the loops are cropped perfectly.

Are you meaning a audible click in Live after rendering, not a audible click in rendered file.

Regards
Hans

After rending the file, the outputed .wav has audible clicks from when new loops start/stop

I just did a new track in Live 2 and did not render it as I went through an analog mixer but did notice that I had to adjust all the clips in the arrangement. I recorded the track by laying out all the samples and triggering the clips by scenes. Many times there were the same clips being triggered and there were audible clicks. In arrangement view it looked as if the tail end and front of clips were overlapping. I ended up just cleaning up everything in the arrangement view and it sounded fine.

telepathic regards,
the kooky scientist