Page 1 of 1
Simpler cannot layer beats
Posted: Wed Feb 03, 2016 2:19 pm
by thegoodsirjames
Hi guys, anyone had this problem? If you make a drum rack with simpler sounds, then programme say a snare and a kick on the same beat, one of them will drop out each time. Happens to me all the time since 9.5
Anyone else have this issue?
Cheers!
Re: Simpler cannot layer beats
Posted: Wed Feb 03, 2016 2:34 pm
by yur2die4
Is it a problem with choke groups?
Re: Simpler cannot layer beats
Posted: Wed Feb 03, 2016 3:12 pm
by thegoodsirjames
it's basically a problem any time I have samples on different drum pads and try to programme two of them on the same beat, eg a kick and a clap. The kick will normally drop out. It's driving me nuts! Thanks for your reply
Re: Simpler cannot layer beats
Posted: Wed Feb 03, 2016 3:36 pm
by [jur]
As yur2die4 suggested, it's probably due to choke groups...
Re: Simpler cannot layer beats
Posted: Wed Feb 03, 2016 3:43 pm
by thegoodsirjames
Yeah guys you are right, thanks for your help. But is there a way to stop Live from automatically putting all the pads into the same choke group when you convert slices to a drum rack? cheers!
Re: Simpler cannot layer beats
Posted: Wed Feb 03, 2016 3:57 pm
by thegoodsirjames
hmm ok so i am reading that simpler puts all the pads into choke group 1 by default, but can't find a way to change this. apparently it can be done from Push...per sample/pad or all at the same time though? Wish it didn't do this by default..