Segment bpm from file name
Posted: Mon May 08, 2017 1:08 pm
When you drop a clip into session view, if the filename ends with xxxbpm, ableton should set segment bpm to this value.
When I am setting up a song for performance, I am manually changing the segment bpm on 40 or so clips to make sure they all loop correctly, even though every clip is cropped into even number of bars. Since you cannot change this for several clips at once (as you can with warp on/oof, loop on/off etc) it is quite tedious.
When I am setting up a song for performance, I am manually changing the segment bpm on 40 or so clips to make sure they all loop correctly, even though every clip is cropped into even number of bars. Since you cannot change this for several clips at once (as you can with warp on/oof, loop on/off etc) it is quite tedious.
