Page 1 of 1
how to apply effect only on 1 note?
Posted: Sat Feb 01, 2020 7:11 pm
by jay99
Hi,
I would like to apply an effect only on 1 note (midi), is it possible?
Thx!
Jay
Re: how to apply effect only on 1 note?
Posted: Sat Feb 01, 2020 9:59 pm
by jestermgee
automation
Re: how to apply effect only on 1 note?
Posted: Sun Feb 02, 2020 4:21 pm
by jay99
Hi jestermgee
I got no idea of what you're talking about.
I'm new, can you give me more details please?
Thx.
Re: how to apply effect only on 1 note?
Posted: Sun Feb 02, 2020 9:01 pm
by jestermgee
Record the effect you want (switch it on) at the point you want the effect.
Re: how to apply effect only on 1 note?
Posted: Mon Feb 03, 2020 4:34 am
by jay99
Ok,
I didn't know what was Automation.
I made some research and it seem that i got a lot of reading to do
Thx.
Re: how to apply effect only on 1 note?
Posted: Mon Feb 03, 2020 5:07 am
by dubstar123
If you can't get the automation right. Like if it is delay and turning it off before the next note sounds weird you can always have that 1 note on a duplicate track and apple the effect just to that track.
I have done this a good bit with percussion elements. Certain Congo hits with a big reverb but others not. Certain hi hat hits with a little phaser on it but not others etc.
Dunno if it's the most efficient but it's a way that I figured out doing it to my liking.
Re: how to apply effect only on 1 note?
Posted: Mon Feb 03, 2020 7:01 am
by jestermgee
dubstar123 wrote: ↑Mon Feb 03, 2020 5:07 am
If you can't get the automation right. Like if it is delay and turning it off before the next note sounds weird you can always have that 1 note on a duplicate track and apple the effect just to that track.
I have done this a good bit with percussion elements. Certain Congo hits with a big reverb but others not. Certain hi hat hits with a little phaser on it but not others etc.
Dunno if it's the most efficient but it's a way that I figured out doing it to my liking.
It's probably easier to either create a multi-channel setup for drums and send each element to a different audio channel for effects or to create a send effect and automate the send control when you need to trigger the effect which will allow the effects tail to still carry when you remove the input. Lots of different ways to do it.
Re: how to apply effect only on 1 note?
Posted: Mon Feb 03, 2020 5:14 pm
by [jur]
One other solution would implies rack's chains or note range.
Re: how to apply effect only on 1 note?
Posted: Sat Feb 08, 2020 1:32 am
by jay99
Thx for the hints!
Re: how to apply effect only on 1 note?
Posted: Sat Feb 08, 2020 1:37 am
by jay99
jestermgee wrote: ↑Mon Feb 03, 2020 7:01 am
It's probably easier to either create a multi-channel setup for drums and send each element to a different audio channel for effects or to create a send effect and automate the send control when you need to trigger the effect which will allow the effects tail to still carry when you remove the input. Lots of different ways to do it.
I have to learn to do that!