Page 1 of 1
Using 2 Push Units at once
Posted: Tue Feb 23, 2021 8:58 am
by R.
I have two Push units - one Push 1 and one Push 2. Can I set it up so they both navigate ableton at the same time? At the moment they both navigate the same functions.
This article says no
https://help.ableton.com/hc/en-us/artic ... ltaneously
Thanks for any tips
Re: Using 2 Push Units at once
Posted: Tue Feb 23, 2021 3:19 pm
by Tarekith
No sorry, that is not supported.
Re: Using 2 Push Units at once
Posted: Wed Apr 21, 2021 9:57 am
by R.
Just going back to this briefly.
I had push one and push two running side by side quite nicely. They didn't function entirely as two separate units but they did what I wanted them to as sequencers.
I got another push two just to have a little test only one device really registers with the software. On one push I have usual functionality and on the other it is just a blank screen. Any suggestions as to what I might be able to do in the Midi controllers section of Ableton to remedy this or is this just the brick wall Im running into of having two of the same unit?
Thanks
Re: Using 2 Push Units at once
Posted: Wed Apr 21, 2021 2:01 pm
by Tarekith
Brick wall I’m afraid, this just isn’t something that’s supported with two Push 2’s.
Re: Using 2 Push Units at once
Posted: Wed Apr 21, 2021 2:47 pm
by R.
ooooo brick walls hurt