M4L LFO In Ableton 11. Going to 0
Posted: Wed Mar 03, 2021 2:17 am
So I like to use the LFO in random mode a lot. I use it on a chain selector in racks that I have made to select samples in a 128.
Since 11 came out the LFO always goes to zero a lot. So I am getting the same of one sample.
Has anyone experienced this?
Even if i put another LFO on the offset it goes to the zero position a lot.
Anyone else using something else to get the same effect?
Since 11 came out the LFO always goes to zero a lot. So I am getting the same of one sample.
Has anyone experienced this?
Even if i put another LFO on the offset it goes to the zero position a lot.
Anyone else using something else to get the same effect?