Moving a clip to an other slot->cursor jump no more scrub
Posted: Sun Jul 31, 2005 9:42 pm
Setup a warped clip, 193 bars long.
Global quant 1 bar
clip quant global
start 1.1.1
end 65.1.1
loop off
pos 1.1.1
lenght 9.0.0
Trigger the clip in his slot
Scrub it after the end marker.
Move the clip to an other slot in the same track.
Cursor jumps (audio too) somewhere randomly in the clip
scrubbing doesn´t work anymore after this
Switch loop on
Do the same as before, but scrub the clip somewhere right to the loop brace
Move the clip
cursor jumps inside the looped area
now scrub it between loop and end marker
scrub works normal now, but the clip will not stop at the end marker, it continous until it´s waveform end.
I think it´s not a good idea that you can srub a clip after it´s theoretical end pos,
that should never be possible as it could not happen for a simply triggered clip, but I think you know already.
Greetings
Global quant 1 bar
clip quant global
start 1.1.1
end 65.1.1
loop off
pos 1.1.1
lenght 9.0.0
Trigger the clip in his slot
Scrub it after the end marker.
Move the clip to an other slot in the same track.
Cursor jumps (audio too) somewhere randomly in the clip
scrubbing doesn´t work anymore after this
Switch loop on
Do the same as before, but scrub the clip somewhere right to the loop brace
Move the clip
cursor jumps inside the looped area
now scrub it between loop and end marker
scrub works normal now, but the clip will not stop at the end marker, it continous until it´s waveform end.
I think it´s not a good idea that you can srub a clip after it´s theoretical end pos,
that should never be possible as it could not happen for a simply triggered clip, but I think you know already.
Greetings