Ableton Forum

Anyone else see this? Clicking the master volume encoder doesn't change the outputs for me. I can just change the main outs, not headphone volume.

Same here with the controller Version of push3.

Don't forget that Cue and Headphones aren't necessary the same depending on your setup. Just saying as I personally remember being confused a few times.

Yep - but pressing the volume encoder does nothing. I can’t select different outputs at all to change volume.

eclipxe wrote: ↑

Sat May 27, 2023 1:38 pm

Yep - but pressing the volume encoder does nothing. I can’t select different outputs at all to change volume.

Oh, ok...
Did you update it too v1.1, or are you still on the factory version?

I've noticed that it doesn't show on the screen when the screen is on certain things. I will try to recreate it. It would still raise and lower the volume but you couldn't see which volume you were raising.

[jur] wrote: ↑

Sat May 27, 2023 1:46 pm

eclipxe wrote: ↑

Sat May 27, 2023 1:38 pm

Yep - but pressing the volume encoder does nothing. I can’t select different outputs at all to change volume.

Oh, ok...
Did you update it too v1.1, or are you still on the factory version?

Yep on 1.1. Did. A factory reset and problem is still there. I sure hope my hardware isn’t broken

You have to press the encoder down to change it to headphone

He already said pressing the encoder does nothing...

he said click? edit - also seen he said pressed

It only clicks when you press it

BTW did any else fail to get the startup tutorial when first powering up their Push?

The first thing mine did was display that "unexpectedly quit" message about recoving a previous project. It was fresh out of the box! Then apparently it's supposed to go to the welcome screen. Mine didn't do that.

102455 wrote: ↑

Sun May 28, 2023 2:25 pm

The first thing mine did was display that "unexpectedly quit" message about recoving a previous project. It was fresh out of the box! Then apparently it's supposed to go to the welcome screen. Mine didn't do that.

That for sure is surprising, but it is working now, right?
Make sure to update to v1.1 asap. The factory software version isn't stable enough.

Yes, I updated immediately after connecting to wifi, and it seems to be behaving itself now.

I quite like the automated file naming when saving

I have the same problem, it only changes if i push down a lot harder and hold for about 2 seconds and let go. It was instant the first few times I switched between them. I updated to 1.1 before this even started happening

cjonesnyc wrote: ↑

Tue May 30, 2023 3:22 pm

I have the same problem, it only changes if i push down a lot harder and hold for about 2 seconds and let go. It was instant the first few times I switched between them.

Did you update to v1.1?