Inverted / Ascending Saw waveform in Wavetable LFOs

[paulpoitier]

Hi all,

I can't figure out a way to change the direction of the saw waveforms in Wavetable's LFO section.

I think this is clear, but to clarify further...

By default, each saw waveform in the LFO starts at it's maximum level and descends at 90° to it's lowest. It is a slope descending from left to right. I would like to create the opposite, a waveform with a slope that ascends from left to right, then drops to it's minimum and ascends again.

Thanks in advance,

P

[doubleUG]

triangle with shape 100%

[paulpoitier]

ah perfect, thank you! seems kinda counter-intuitive but works