Page 1 of 1
Shifter not working within Drum Rack when its Delay is on
Posted: Sun Oct 29, 2023 9:19 pm
by Korhan
Hi everyone,
Has anyone encountered this? When I place a Shifter in a drum rack, either within a cell or in the send/return, it stops outputting processed sound when I turn its Delay on. It passes the dry sound through, but nothing else (at 100% Wet, no sound comes out). Without the Delay, it works fine
It works fine with the Delay on, when placed after the Drum Rack.
Re: Shifter not working within Drum Rack when its Delay is on
Posted: Tue Oct 31, 2023 10:47 pm
by [jur]
Hey Korhan, which Live version?
Re: Shifter not working within Drum Rack when its Delay is on
Posted: Tue Oct 31, 2023 10:48 pm
by Korhan
10.10
11 12 13 Versions have no bugfixes.
Re: Shifter not working within Drum Rack when its Delay is on
Posted: Tue Oct 31, 2023 10:54 pm
by [jur]
Ok, I just tried in L11.3.13 and I can reproduce. But if you disable and re-enable the Delay then it works as expected.
If you then change Freq Shift <> Ring the output might get cut once again, and you need to redo off/on Delay steps.
Doesn't seem to happen in Pitch shift mode though.
Interestingly after switching the modes several times and re-enabling the Delay it seems like the bug disappeared. But deleting Shifter and loading a new instance and the bug was back.
Can you report to
Support please?
Re: Shifter not working within Drum Rack when its Delay is on
Posted: Tue Oct 31, 2023 10:58 pm
by Korhan
THank you for taking the time to reproduce the bug.
I'll report to support along with another bug. Phaser's LFO stopped working... Same in all three modes. EVen after Live was restarted. Push 3 was connected.
The moment I tell myself "ah, I can go back to performing with Live", Live says "not so fast..."
