Ableton Forum

Hello, I have a modular system from Erica Synths with a bassline. I tried to use my Squarp Hapax to control the bassline module with CV/Gate, and it works, but for accents, it requires 10V, which I believe the Push 3 can do.
I'm not sure how to set this up on the Push though. I see there is a pedal 1 and 2 and these are 1/4" TRS I believe. So If I get a TRS 1/4 to dual 1/8" mono adapter like this, I configure push to use 1 as gate and one as CV correct?

https://www.amazon.com/Nightwolf-6-35mm ... B073WR715P

Yes, in regards your understanding of what a suitable adaptor will give you. However that particular adaptor you link to has a contradiction between the full product title and what it says in the description. The title says the female ports are TS, but the description says they are stereo and goes on about using them to listen on two pairs of headphones.

So you should probably choose a different adaptor where it is completely certain that the other end of the cable is certainly two mono TS.