Ableton Forum

Posted: **Thu May 02, 2024 5:16 pm**

The "tempo" is always displayed once I touched the encoder.
I've noticed that if I remove the encoder's cap it disapears. If I put it back on it displays again.
Anyone noticed any similarity?

Posted: **Thu May 02, 2024 10:13 pm**

That happened with mine too, it was a hardware fault and Ableton replaced my Push 3 once I contacted them about the issue.

Posted: **Fri May 03, 2024 1:44 pm**

I see. Thanks Tarekith

Ableton Forum

Push 3 "tempo" gets stuck on display

Push 3 "tempo" gets stuck on display

Re: Push 3 "tempo" gets stuck on display

Re: Push 3 "tempo" gets stuck on display